XgenPlusXgenPlusHelp Center

Connect Claude Code to XgenPlus Mail

To connect Claude Code, make your token, then run claude mcp add --transport http xgenplus https://mcp.xgenplus.com/mcp --header "Authorization: Bearer <TOKEN>" in a terminal. Check it with claude mcp list, which should show the server as connected. In a Claude Code session, type /mcp to see the server and its tools.

For: EveryoneWebAI

How to connect Claude Code

  1. Create your agent password and make your token.
  2. Run the command below in a terminal, replacing <TOKEN> with your token.
  3. Run claude mcp list and check that xgenplus shows as connected.
  4. Start Claude Code and type /mcp to see the XgenPlus tools.

When to use it

Rohit, a developer at acme.in, asks Claude Code to find the build-failure mails from the last week and list which projects they came from, without leaving his terminal.

Command

claude mcp add --transport http xgenplus https://mcp.xgenplus.com/mcp --header "Authorization: Bearer <TOKEN>"

Good to know

  • claude mcp remove xgenplus removes the server.
  • Your token is saved in Claude Code's settings on your computer. Do not add it to a shared project file or a code repository.

Common questions

claude mcp list shows the server failed to connect. Why?

Usually the token is wrong. Claude Code saves the server without checking the token, so remove it with claude mcp remove xgenplus, make the token again and add it again.

Was this page helpful? Updated 2026-10-29